![]() ![]() ![]() It also has the advantage that you can remove and reinsert the bolt repeatedly since the tube part doesn't fall behind the wall like the single use wing nut style. However, the hole must match the fastener diameter if the hole is oversize it can't be properly set. Allow the area to dry completely when you’re finished. Run the cloth or paper towel over the screw hole and surrounding wood. Wet a clean, lint-free cloth or sturdy paper towel and squeeze out the excess water. An alternative molly bolt that does not have this problem is a hollow drive molly bolt that does not have a separate nut but consists of a tubular shaft that compresses behind the wall when the bolt is screwed in the shaft fills the hole so there is no wiggling around of the bolt. Clean the surface with a damp cloth or paper towel. Over time this can allow something that is used frequently (like a TP holder) to move around a bit and sometimes the bolt loosens. The fastener you are talking about - a molly bolt with a wing nut - is not as good in my opinion as the nut makes a hole much bigger in diameter than the bolt itself. A single, typical threaded insert has a pullout strength of at least 80 pounds, so they are entirely adequate for this job as long as the size is properly matched to the hole.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |